|
Post by Legionnaire on Jan 15, 2009 10:20:56 GMT
I need a bit of advice lads, on the latest delivery at least two of my minis have disfigured/ missing pistol (semi-automatic ones)barrels, annoying enough. Do anyone have some good advice how to fix this? I talked to John and he might have some extra guns lying around. Will a piece from a matchstick glued on cut it?
Thanks,
The Swede.
|
|
|
Post by Matt on Jan 15, 2009 10:26:30 GMT
Use some green stuff or a bit of brass wire or the end of a paper clip drilled on.
All sounds rather advanced. Have a look on the GW website for how to use Green Stuff or just google it ;D
Or alternatively stick your bottom lip out - shout loudly and demand the company replace them or you'll send some very serious looking gentlemen round who'll beat them until they do!
Well maybe not but I would try and get then replaced if you can.
|
|
|
Post by Mark Wightman on Jan 15, 2009 11:14:38 GMT
I'm with Matt here; I'd complain to the company. They'll probably replace them. Most miniature manufacturers rely on goodwill and will replace miscasts (even GW) without batting an eyelid.
Stand up for your rights!
|
|
|
Post by Legionnaire on Jan 16, 2009 15:47:31 GMT
Thanks guys. I contacted Mark Copplestone (used to work for Foundry) at Copplestone Castings stating my issue. I offered to return the miscasts so he could recycle them, and in return he offered to do them again AND ship a few other figures as compensation for my troubles! I will take him up on his offer and everyone will get out with their Honour intact. ;D
The Swede.
|
|